Akai MPC 60 Manual del operador descargar pdf (Pagina 64)

Chapter 3: Recording Sequences

Page 58

1. NO: The metronome is heard during Record or Overdub

modes, but not while in Play mode.

2. YES: The metronome is heard in Play, as well as in Record

and Overdub modes.

• The Count in field:

This is a choice field with two options:

1. REC+PLAY: If the Count In light is on, the count in will be

heard before recording, overdubbing, or playing.

2. REC ONLY: If the Count In light is on, the count in will only be

heard before recording.

• The Rate field:

This choice field controls the note value of the metronome. Normally, the

metronome plays 1/4-notes. In this field it is possible to change that

value to one of eight options:

1/4 NOTE

1/4 TRPLT

1/8 NOTE

1/8 TRPLT

1/16 NOTE

1/16 TRPLT

1/32 NOTE

1/32 TRPLT

The Foot switches /Free Memory section:

• The Foot1 and Foot2 fields:

These two fields determine the function of foot switches connected to the

rear panel FOOT SW 1 and 2 inputs. These are choice fields, each of

which can be set independently to one of the following options:

PLAY/STOP:

Press the foot switch once for PLAY, press again for STOP.

PLAY-STRT/STP (Play start /stop):

Press once for PLAY START, press again for STOP.

ERASE:

Press to duplicate the function of pressing ERASE. This is very

useful for hands-free use of the real-time erase function.

TIMING CORECT (Timing correct):

Press to duplicate the function of pressing the TIMING

CORRECT key. This is very useful for hands-free use of the

Note Repeat function.

'+':

Press to duplicate the function of turning the data entry knob one

step to the right.

1 2 ... 59 60 61 62 63 64 65 66 67 68 69 ... 240 241

Comentarios a estos manuales

Sin comentarios

Akai MPC 60 Manual del operador Pagina 64

Comentarios a estos manuales

Relacionado con productos y manuales para Sintetizador Akai MPC 60