Akai S1000 Series Manual del operador descargar pdf (Pagina 75)

MIDI

MIDI data dumps

Samples can be transferred between the S1000 and other samplers via MIDI. If you do this,

you must make a MIDI loop (MIDI OUT of the S1000 connected to MIDI IN of the other

sampler, and vice versa). This is necessary because of the way in which MIDI sample

dumps are performed (in computer terms, a handshake protocol with error

detection/correction).

Though the S1000 is a 16-bit sampler, it can accept samples from other samplers, including

those from other manufacturers which use a lower bit resolution, padding low bits with

zeroes. If transmitting to another sampler which uses fewer bits, it simply truncates the low

bits. Instead of another sampler, samples can be transmitted to and accepted from other

devices (such as computers) which are capable of storing and/or editing sample data.

However, in this section we will always refer to the other device as a "sampler".

The first parameter, "

channel", does not refer to a MIDI channel, but a "logical channel"

used in System Exclusive protocol. Both samplers must be set to the same channel for

transfer to take place.

The "

type of transmission" refers to what will actually be transmitted over MIDI. This

can be ALL PROGRAMS, ALL SAMPLES, SINGLE PROGRAM, SINGLE SAMPLE, and

DRUM SETTINGS. The meanings of these values are self-explanatory.

Two protocols for sample transfer are available, "

STANDARD", which conforms to the MIDI

sample dump standard, and "S1000", which is a superset of the MIDI sample dump standard.

Use the "S1000" setting only if you are transferring data between two S1000-compatible

machines (this includes the S1000, S1000KB, S1000HD, and the S1000PB).

If you have selected SINGLE PROGRAM transmission, the next parameter, "

single

program

", allows you to specify the program which will be transmitted.

If you have selected SINGLE SAMPLE transmission, the next parameter, "

single

sample

", allows you to specify the sample which will be transmitted.

You can override the default sample number (based on the order in which samples appear in

the S1000's memory) with the last parameter, "

sample number override".

When all the parameters are set up, press the SEND button to initiate transmission. Once the

handshake protocol has been successfully initiated between the two devices, data transfer

will take place. A new soft key,

ABORT, will appear. Press this if you want to terminate the

transmission prematurely.

age 6

Version 2.0 89/11

1 2 ... 70 71 72 73 74 75 76 77 78 79 80 ... 95 96

Comentarios a estos manuales

Sin comentarios

Akai S1000 Series Manual del operador Pagina 75

Comentarios a estos manuales

Relacionado con productos y manuales para Equipo de grabación Akai S1000 Series