Akai S1000 Series Manual del operador descargar pdf (Pagina 69)

Sam

ler functions

The next parameter allows you to set the overall volume of the program (00 to 99)

relative to any other programs being played.

The three parameters following affect the volume of the sound as controlled by three

keyboard parameters: velocity, key position, and aftertouch (pressure).

The first,

"vel>loud", can take values from +50 to -50. If this value is positive, the

higher the velocity, the louder the sound produced, and a negative value will produce a

quieter sound with a high key velocity. Setting two programs in the same keyrange, one

with this value set positive, and one with it set negative, can prcduce a velocity

cross-fading effect.

The next parameter, “key> loud", determines the volume of the sound depending on

the key being played. When this parameter is positive, the higher the key, the louder the

sound, and when negative, the higher the key, the quieter the sound (like most acoustic

instruments).

Finally, in this column,

"prs>loud" allows you to specify the effect of aftertouch on

program volume. Positive values will increase the volume as aftertouch is applied, and

negative numbers will reduce the volume when aftertouch is applied.

"mono out" specifies the output channel (OFF or 1 to 8) from which the program is

played. Note that this setting interacts with the "out" parameter in the SMP2 page of the

keygroup setting, and is used as the "base" number to which offsets set up in the SMP2

page are added. If this value is set to OFF, then the program will only be output from the

stereo connectors.

As mentioned in the guide to the rear panel, programs can be sent through the S1000's

own effects loop prior to output. The

"efct out." parameter can be set ON or OFF

individually for each program. If you are playing a large number of programs

simultaneously, then you might consider using the EFFECT OUT as an extra individual

output channel.

The "ster. 1ev" parameter allows you to set the level of the program from the stereo

outputs. It has no effect on the level from individual outputs. This parameter interacts

with all other volume settings you have made for this program, notably the

"loudness"

parameter. If the loudness parameter is set to 00, no sound will be produced from the

stereo outputs, even if the

"ster .1ev" parameter is set to 99.

e 61

Version 2.0 89/11

1 2 ... 64 65 66 67 68 69 70 71 72 73 74 ... 95 96

Sin comentarios

Akai S1000 Series Manual del operador Pagina 69